Failure at line 13

Discussions concerning TrueSTUDIO for STM32 9.0.0 and later versions.

Moderators: Markus Girdland, Mattias Norlander

Chettuser
Posts: 4
Joined: Wed Apr 10, 2019 6:10 pm

Re: Failure at line 13

Postby Chettuser » Tue May 07, 2019 9:43 am

I also repeated how it was done in the manual, but I also get an error:

Code: Select all

Hardware watchpoint supported by the target
SWD frequency = 4000 kHz
ST-LINK Firmware version : V2J33S25
Device ID: 0x460
PC: 0x1fff2b44
ST-LINK device status: HALT_MODE
ST-LINK detects target voltage = 3.22 V
ST-LINK device status: HALT_MODE
ST-LINK device initialization OK
Waiting for debugger connection...
Waiting for connection on port 61234...
Accepted connection on port 61234...
Debugger connected
TraceCaptureStart and SWV event set to APP_TRUE
ST-LINK device status: RUN_MODE
Received Ctrl-C from the client
TraceCaptureStart and SWV event set to APP_FALSE (1)
Device not halted(0), performing Ctrl-C
Device halted

After pressing PAUSE:

Code: Select all

Program received signal SIGINT, Interrupt.
0x1fff2122 in ?? ()

The address changes every time:
No source available for "0x1fff2136"

:?:

alexandr idushy
Posts: 5
Joined: Fri May 03, 2019 4:17 pm

Re: Failure at line 13

Postby alexandr idushy » Tue May 07, 2019 10:26 am

it is other story. i dot`t know how this resolve.

alexandr idushy
Posts: 5
Joined: Fri May 03, 2019 4:17 pm

Re: Failure at line 13

Postby alexandr idushy » Sat May 11, 2019 8:21 am

try the simple project to make sure, the problem is with debugging.

Chettuser
Posts: 4
Joined: Wed Apr 10, 2019 6:10 pm

Re: Failure at line 13

Postby Chettuser » Fri May 17, 2019 6:13 pm

I tried to install IDE on someone else's computer. And ... Everything works there! I do not know the reason. :oops:
I do not want to reinstall the system.

alexandr idushy
Posts: 5
Joined: Fri May 03, 2019 4:17 pm

Re: Failure at line 13

Postby alexandr idushy » Fri May 17, 2019 6:29 pm

all may be in this great and terrifying worldd ;)

alexandr idushy
Posts: 5
Joined: Fri May 03, 2019 4:17 pm

Re: Failure at line 13

Postby alexandr idushy » Fri May 17, 2019 6:35 pm

try reinstall atollic.
try install near atollic other version.
reinstall drivers.
win update.
... and
reinstall Win, sorry


Return to “TrueSTUDIO for STM32 discussions”

Who is online

Users browsing this forum: No registered users and 0 guests