J-link option not available when setting up a project

Discussions concerning TrueSTUDIO for STM32 9.0.0 and later versions.

Moderators: Markus Girdland, Mattias Norlander

orangedwarf
Posts: 2
Joined: Mon Feb 03, 2020 10:46 pm

J-link option not available when setting up a project

Postby orangedwarf » Mon Feb 03, 2020 11:16 pm

Hi,
I am setting up my first STM32L152RE (Nucleo) project using True Studio.
I have used the STLink reflash utility from Segger to replace the firmware of an existing ST-LINK on-board with firmware from SEGGER.

I set up a standard embedded project and am able to select L152RE board.
The issue is that when I get to debugger configuration, the only option available is ST-Link. I am not able to select J-link.
I have installed the J-link drivers as part of the installation.
Can someone please help.

Return to “TrueSTUDIO for STM32 discussions”

Who is online

Users browsing this forum: No registered users and 1 guest