Page 1 of 1

STM32 first project

Posted: Thu Oct 24, 2019 8:33 am
by panoss
Hello everybody.
In a few days I'm planning to start building a project with STM32F030F4P6. (it 's just an STM32F030F4P6, not a development board)
It 's a starting LED blink project as it 's my first time I 'll try anything with an STM32 MCU.
I want to use the internal oscillator, not any external crystal.
I have installed STM32CubeMX and Atollic TrueSTUDIO.
As a programmer I 'll be using an ST-LINK V2.

I 'm trying to make a step by step tutorial for my self. :mrgreen:

So my first concern is the hardware: I 'm going to make a breakout board and connect it this way with the ST-Link:
ST-LINK.....STM32F030F4P6
RST.........NRST
SWDIO.....SWDIO
SWCLK.....SWCLK
3.3V........VDD
GND........VSS

Image

(the STM32F030F4P6 will be getting powered from the ST-LINK)

Is this the correct way to connect them?