Page 1 of 1

FRDM_KL25Z Target problems

Posted: Mon Nov 30, 2015 5:32 pm
by sobellinni
I've got an FRDM_KL25Z

no matter what i do I cannot connect the target to the board using the P&E gdb

It works on Mbed, Keil, and Crossworks without difficulty

any ideas

Hi, Have you consulted the User

Posted: Tue Dec 01, 2015 11:35 am
by Mattias Norlander
Hi,

Have you consulted the User guide pdf? You find it in TrueSTUDIO by: Help --> Information Center
The User Guide has a chapter called "P&E GDB SERVER FOR KINETISĀ® DEVICES", page 204 currently.

The option "Start server on Startup" no longer seem to exist. Therefore click "Start Server when you have applied all settings in step 2-4 on page 206.

Any progress?

This may be a P&E

Posted: Wed Dec 09, 2015 10:00 pm
by tba10596
This may be a P&E problem, but I am not seeing a PORT show up after I have entered the proper information and pressed reset. Hence, I am unable to connect when I go to Atollic Debug. Has anyone been able to get around this hurdle?
I am using Windows 10, and the Port is seen by Windows when I plug in the board.
I do depress the reset button on the board to allow it to go into boot mode. I understand that is the proper thing to
do for the FRDM_KL25Z.

Regards,
Todd Anderson

Hi, Sorry for the delay. And

Posted: Fri Dec 11, 2015 12:58 pm
by Mattias Norlander
Hi,

Sorry for the delay. And sorry for the background noise in the video, but, try this:
https://youtu.be/9_nW35Ablz4

Kind regards, Mattias