Setting the frequency on SWD debugger

Discuss how to use the features of Atollic TrueSTUDIO, including the editor, assembler, C/C++ compiler, linker, debugger, static code analysis and team collaboration tools.

Moderators: Markus Girdland, Mattias Norlander

Post Singularity
Posts: 1
Joined: Fri Mar 22, 2019 11:21 am

Setting the frequency on SWD debugger

Postby Post Singularity » Fri Mar 22, 2019 11:24 am

The title says it all. I have a STM32F103C8T6 that i would like to debug within Atollic TrueStudio.
I have to load the code with ST-LINK_CLI and that works fine. However the debugger can't seem to connect to the board and debug aways fails. The reason i think is that my board doesn't support debug at 4MHz (that is the reason i have to upload the code with ST-LINK_CLI because with external loader i can set up the right frequency).

How does one change the frequency for the debugger?

Return to “Atollic TrueSTUDIO tool discussions”

Who is online

Users browsing this forum: No registered users and 1 guest