Search found 4 matches

by forcewin
Thu Jul 04, 2019 3:07 pm
Forum: Atollic TrueSTUDIO tool discussions
Topic: MCU don't run after out of debug
Replies: 3
Views: 253

Re: MCU don't run after out of debug

ST-LINK =HALT_MODE appears in Truestudio's log file I found Core state: Halted in the STM32 ST-LINK Utility program After loading the hex file, enter halt_mode. I do not know why. It's too hard to start the MCU program right now. Downgrade stm32cubeMx and try installing again. Downgrade cubemx and t...
by forcewin
Thu Jul 04, 2019 1:14 pm
Forum: Atollic TrueSTUDIO tool discussions
Topic: MCU don't run after out of debug
Replies: 3
Views: 253

Re: MCU don't run after out of debug

my settings is.. C/C++ Build / Settings / Target Settings STM32F746IG: FLASH: 1024KB DTCMRAM: 64KB SRAM1: 240KB SRAM2: 16KB Code Location: FLASH Endianell: Little endian C/C++ Build / Settings / Tool Settings Other / Output format: Intel Hex C/C++ Build / Settings / Build Steps Post-build steps / Co...
by forcewin
Thu Jul 04, 2019 7:58 am
Forum: Atollic TrueSTUDIO tool discussions
Topic: MCU don't run after out of debug
Replies: 3
Views: 253

Re: MCU don't run after out of debug

I fail again today. The ST-LINK driver is working well startup scripts also seem to be wrong. I do not see the word error. Debug is also good. Very very good But, when debug is finished, mcu is halt-halt-halt... endless stopping~. The same is true if finished quit after load. Sky and earth do not op...
by forcewin
Wed Jul 03, 2019 2:31 pm
Forum: Atollic TrueSTUDIO tool discussions
Topic: MCU don't run after out of debug
Replies: 3
Views: 253

MCU don't run after out of debug

I am still using truestudio, stm32cubeMx and stm32F746. By the way, suddenly the MCUs are not working. It works fine in debug mode, but stops when you exit debug mode. I can reinstall truestudio and cubemx, and also erased various vaccine programs... I am trying to modify the debug configuration for...

Go to advanced search