Search found 3 matches

by jprinster
Wed Jul 17, 2019 4:05 pm
Forum: Atollic TrueSTUDIO tool discussions
Topic: Failed to connect to device. Please check power and cabling to target.
Replies: 9
Views: 3748

Re: Failed to connect to device. Please check power and cabling to target.

I have the same problem. Even when ST-LINK Utility is closed the error occurs. Specifically I get the following:
Target unknown error 19
Error in initializing ST-LINK device.
Reason: Unknown. Please check power and cabling to target.
by jprinster
Wed Jul 17, 2019 3:53 pm
Forum: Atollic TrueSTUDIO tool discussions
Topic: ST-Link Target unknown error 19
Replies: 0
Views: 144

ST-Link Target unknown error 19

I use Atollic TS 9.2.0 and an ST-LINK/V2 with two custom boards that have different processors. In both cases I have a bootloader and the main application is loaded higher in flash. For the board with the STM32F051 I can debug with no problems when the code is at the higher location. For the board w...
by jprinster
Wed Jul 11, 2018 11:17 pm
Forum: Embedded target code development discussions
Topic: Locating code higher in flash above bootloader
Replies: 3
Views: 789

Locating code higher in flash above bootloader

I am running on an STM32F051C8. I have a bootloader that is located at the bottom of the flash at 0x08000000. I want to place the main application at 0x08003000 and be able to run the debugger with the code located there. What do I need to modify to have TrueStudio place the code there and run? Than...

Go to advanced search